MNS LOW-VOLTAGE DRAW-OUT SEITCH CABINET

MNS LOW-VOLTAGE DRAW-OUT SEITCH CABINET

The MNS low-voltage withdrawable switchgear product has a compact design, strong structural versatility, flexible assembly, and adopts standard module design. It is a safe, economical, reasonable, and reliable new type of low-voltage withdrawable switchgear.

There are multiple options available for users to choose from, such as exit lines. This device complies with national and industry standards. The MNS type low-voltage withdrawable switchgear is suitable for three-phase AC 50, 60Hz, rated voltage 660V, and rated current below 4000A in three-phase four wire and three-phase five wire power systems, used for receiving and distributing electrical energy. Widely used in power distribution centers PC and motor control centers MCC for power plants, substations, factories, mines, and high-rise buildings.

MNS LOW-VOLTAGE DRAW-OUT SEITCH CABINET

LOW LOSS

HIGH ENERGY EFFICIENCY

WIDELY APPLICABLE

SEALED OIL TANK

Applicable Scenarios

  1. The ambient air temperature shall not exceed+40 ° C, not be lower than -5 ° C, and the average temperature within 24 hours shall not exceed+35 ° C.
  2. The relative humidity of the surrounding air should not exceed 50% at a maximum temperature of 40 ° C, and a higher relative humidity is allowed at lower temperatures, such as 90% at+20 ° C. However, it should be considered that moderate condensation may occasionally occur due to temperature changes.
  3. For indoor use, the altitude of the usage location shall not exceed 2000m
  4. It should be installed in a place where there is no severe vibration and impact, and where electrical components are not subjected to undue corrosion.

Core Parameters

ProjectUnitParameters
Rated voltageVAC380、AC660
Rated frequencyHZ50
Rated currentMaximum working current of horizontal busbarA5500
Maximum working current of vertical busbar1000
Rated short-time withstand currentkA100
Rated peak withstand currentkA220
Dielectric strengthV/1min2500
Rated insulation voltageV660
Control the capacity of the electric motorkW0.5~155
Protection gradeIP30/IP40
Dimensions (width x depth x height)mm600（800、1000）×600（800、1000）×2200

Competitive Comparison

FeatureMNS LOW-VOLTAGE DRAW-OUT SEITCH CABINETConventional Similar Transformer
No-load lossLower (energy-saving series)Higher standard series
Partial dischargeLow partial discharge, high reliabilityStandard level
MaintenanceMaintenance-free, low operational costPeriodic maintenance required
Fire safetyFlame retardant & explosion-proofVaries

Application Areas

transportation

industry

Urban Community

agriculture

Frequently Asked Questions

What is the rated capacity of MNS LOW-VOLTAGE DRAW-OUT SEITCH CABINET?

The MNS LOW-VOLTAGE DRAW-OUT SEITCH CABINET is available in a range of rated power options; the exact kVA for your application is listed in the Core Parameters table.

What are the main advantages of MNS LOW-VOLTAGE DRAW-OUT SEITCH CABINET?

Low loss and high energy efficiency, low partial discharge, high mechanical strength, short-circuit and lightning resistance, flame retardant, maintenance-free and compact footprint.

What are the applicable scenarios for MNS LOW-VOLTAGE DRAW-OUT SEITCH CABINET?

It is suitable for medium and high voltage power transmission and distribution projects, urban communities, industry, transportation and agriculture, meeting continuous operation under conventional and harsh conditions.

Does MNS LOW-VOLTAGE DRAW-OUT SEITCH CABINET require special installation?

No oil discharge tank, fire-fighting or backup power facilities are needed, so it can be installed fully close to the power point with low installation cost.

Related Products and Series